高温煤气脱硫 Ⅰ．铁锌基脱硫剂脱硫工艺条件及硫化动力学

用自制的铁酸锌高温煤气脱硫剂研究了硫化氢浓度、硫化温度、空速对脱硫反应及脱硫剂物理性质的影响。结果表明：铁酸锌脱硫剂的反应活性随着Ｈ２Ｓ浓度及硫化温度的升高而升高，脱硫温度为５５０℃时，脱硫剂的硫容量最高，脱硫剂的物理性质基本保持不变；硫化空速为８５０ｈ￣（－１）时，空速和反应时间同时达到最大值。硫化反应可用未反应核收缩模型描述，得到了转化率与时间之间的动力学方程。     

Selective preconcentration and determination of iodine species in milk samples using polymer inclusion sorbent

A method to determine low levels of iodine species namely I⁻ and IO₃⁻ in aqueous samples was developed and applied to milk and milk powder samples. It is based on selective preconcentration of I⁻ in polymer inclusion sorbent (PIS) and neutron activation analysis (NAA) of I⁻ sorbed in PIS. The PIS was found to be highly selective for I⁻ in presence of IO₃⁻ and other anions commonly present in the milk samples. In order to preconcentrate total I⁻ + IO₃⁻ content in the PIS, IO₃⁻ was reduced to I⁻ using a mixture of acetic acid and ascorbic acid. It was found that total iodine content in milk could be determined with epithermal neutron activation analysis (ENAA). A scheme was developed to determine I⁻, IO₃⁻ and total iodine. The developed method was applied to milk reference materials (NIST SRM-1549 and IAEA-RM-153 milk powder) and a commercially available milk powder. The scheme for estimation of iodine in different forms was validated by using reference material NIST SRM-1549.     

焦煤中添加废塑料和脱硫剂的焦化过程研究

在模拟焦化室和焦化条件下，进行了焦煤中直接添加废塑料和脱硫剂后的焦化过程的研究，分析了焦化过程中焦炉煤气H2S脱除效果及脱硫剂和废塑料的添加对焦炭硫和锌及其在焦炭中残留率的影响。结果表明，焦煤的焦化过程中，直接添加ZnO、Fe2O3或冶金粉尘(MD)作为脱硫剂，当关键脱硫组分ZnO和（或）Fe2O3与可挥发性硫的摩尔比(nZn+Fe/nS)为1.2时，焦炉煤气H2S脱除效果均较好，塑料本身的热分解使得焦煤中添加质量分数为5%的废塑料后焦炭产率从81.52％降到77.61％；当焦煤中添加质量分数为5％的废塑料，并以ZnO为脱硫剂时，由于塑料中硫的质量分数相对焦煤要高，所以需要增nZn+Fe/nS到1.7，才能取得较好的煤气脱硫效果，与此同时焦炭中锌和硫的质量分数均有不同程度的增加。     

Efficient strategy for the selective determination of dopamine in human urine by molecularly imprinted solid‐phase extraction

An efficient molecularly imprinted solid‐phase extraction protocol was developed for the separation of dopamine (DA) from human urine. After successful validation of the analytical method using high‐performance liquid chromatography coupled with fluorescence detection, a new strategy for the selective determination of DA in the presence of norepinephrine and epinephrine in human urine was presented. In the proposed protocol, the LODs and quantification for DA were 166 ± 36 and 500 ± 110 nmol/L, respectively, and the total recoveries of DA in the range of 1–15 μmol/L varied between 98.3 and 101.1%. DA was detected in the real urine samples at the level of 47–167 μg/L (0.250–0.895 μmol/L). The superiority of the novel analytical strategy was shown by comparison with the results obtained for a commercially available imprinted sorbent.     

π-hole bonding: A new retention mechanism for the solid phase extraction of polycyclic aromatic hydrocarbons from the hexane extracts of soil samples

In this work, the perfluorobenzene-bonded silica sorbent was tested to adsorb polycyclic aromatic hydrocarbons in hexane. In the comparison experiments, the perfluorobenzene-bonded sorbent's performance was better than octadecyl silica sorbent and phenyl-bonded silica sorbents, which indicated that the π-hole···π bonds between perfluorobenzene and the polycyclic aromatic hydrocarbons were stronger than π···π interactions and hydrophobic interactions in hexane. Then the perfluorobenzene-bonded silica sorbent was applied to solid-phase extraction of 15 polycyclic aromatic hydrocarbons from the hexane extracts of soil samples directly without the solvent replacement, which simplified the soil pretreatment process. And the results showed that under the optimal conditions, the proposed method for the determination of polycyclic aromatic hydrocarbons in the environment soil presented good recoveries and stabilities for the 10 heavier polycyclic aromatic hydrocarbons with the recoveries ranging from 75.1% to 104.6% and the relative standard deviations being in the range of 1.4%–5.8%. The limits of detection of the method varied from 0.1 to 2 ng/g. This work reveals the great application potential of the π-hole bond as a new retention mechanism in the field of solid-phase extraction.     

吸附有苯酚氧化残留物的Cu-Ce/AC吸附 催化剂的氢处理研究

对经苯酚吸附和干态催化氧化过程后吸附有苯酚残留物的活性炭载氧化铜和氧化铈(Cu Ce/AC)进行了氢处理研究。结果表明,氢处理可明显促进残留物的分解,恢复Cu Ce/AC对苯酚的吸附性能,减少在后续苯酚氧化过程中苯酚脱附量。氢处理温度越高,苯酚吸附容量恢复得越好。但氢处理不能恢复Cu Ce/AC对苯酚的催化氧化活性,是由于活性组分晶粒长大所致。     

Study of the factors affecting the performance of microextraction by packed sorbent (MEPS) using liquid scintillation counter and liquid chromatography-tandem mass spectrometry

Microextraction by packed sorbent (MEPS) is a new technique for sample preparation that can be connected on-line with LC or GC. In MEPS, approximately 1-2 mg of the solid packing material is inserted into a syringe (100-250 μL) as a plug. Sample preparation takes place on the packed bed. The bed can be packed or coated to provide selective and suitable sampling conditions. The new method is very promising for extraction of drugs and metabolites from biological samples.In this paper, some factors affecting the performance of MEPS such as recovery, carry-over, leakage, washing volume and elution volume were studied using C18 and hydroxylated polystyrene-divinylbenzene copolymer (ENV+) as sorbents. Radioactively labelled bupivacaine in plasma samples was used as test analyte. For the extraction of this drug, using methanol/water 95:5 (v/v) (0.25% ammonium hydroxide) was used as elution solvent. The analyte response increased with increasing the elution volume and it was linear upp up to 100 μL utilizing liquid scintillation counter. Further, for concentrating the sample, we found that MEPS may be used such that the sample can be drawn through the needle, up and down, several times. The analyte leakage increases as the volume washing increases, though higher washing volumes may also result in cleaner extracts. To eliminate analyte carry-over, the sorbents were washed first with 3 × 250 μL elution solution and then with 3 × 250 μL washing solution. In addition, the reproducibility measurements show relatively good relative standard deviation (RSD) % values concerning analyte recovery and analyte leakage. The present study provides an understanding of basic aspects when optimizing methods for MEPS. In this study, MEPS was used off-line with liquid scintillation counter and on-line with LC-MS/MS.     

Use of itaconic acid-based polymers for solid-phase extraction of deoxynivalenol and application to pasta analysis

Molecular modelling and computational design were used to identify itaconic acid (IA) as a functional monomer with high affinity towards deoxynivalenol (DON), a Fusarium-toxin frequently occurring in cereals. IA-based polymers were photochemically synthesised in dimethyl formamide (porogen) using ethylenglycol dimethacrylate as cross-linker and 1,1′-azo-bis(cyclohexane carbonitrile) as initiator, and the relevant binding interactions with DON in solvents with different polarity were investigated. The performances of the non-imprinted IA-based polymer (blank polymer, BP) and the corresponding molecularly imprinted polymer (MIP) were compared using DON as a template. Both BP and MIP were able to bind about 90% DON either in toluene, water or water containing 5% polyethylene glycol. Non-imprinted polymers with different molar ratios of IA to cross-linker were evaluated as adsorbents for solid-phase extraction (SPE) clean-up and pre-concentration of DON from wheat and pasta samples prior to HPLC analysis. Samples were extracted with PBS/0.1 M EDTA solution and cleaned up through a cartridge containing blank IA-based polymer. The column was washed with PBS (pH 9.2) and the toxin was eluted with methanol and quantified by reversed-phase HPLC with UV detector (λ = 220 nm), using methanol:water:acetic acid (15:85:0.1, v/v/v) as the mobile phase. Effective removal of matrix interferences was observed only for pasta with DON recoveries higher than 70% (RSD < 7%, n = 3) at levels close to or higher than EU regulatory limit.     

Microextraction by packed sorbent and liquid chromatography–tandem mass spectrometry as a tool for quantification of peptides in plasma samples: determination of sensory neuron‐specific receptors agonist BAM8‐22 and antagonist BAM22‐8 in plasma samples

Microextraction by packed sorbent (MEPS) is a miniaturized, solid‐phase extraction (SPE) technique that works online with gas chromatography (GC) and liquid chromatography (LC). Not only is the automation process with MEPS advantageous, but the much smaller volumes of the samples, solvents and dead space in the system also provide other significant advantages such as the speed and the simplicity of the sample preparation process. In this study MEPS has been evaluated for quantification of sensory neuron‐specific receptors agonist (BAM8‐22). Owing to the instability of BAMs, the focus was on fast extraction and determination of the peptide online using LC‐MS/MS. Sorbents such as C2, C8 and ENV+ (hydroxylated polystyrene–divinylbenzene copolymer) were investigated in the present study. MEPS‐C8 gave the best results compared with C2 and ENV and it was used for the method validation. The calibration curve was obtained within the concentration range of 20.0–3045 nmol/L in plasma. The regression correlation coefficients for plasma samples were ≥0.99 for all runs (n = 6). The between‐batch accuracy and precision for BAM8‐22 ranged from ?13 to ?2.0% and from 4.0 to 14%, respectively. Additionally, the accuracy and precision for BAM22‐8 ranged from ?13 to 7.0% and from 3.0 to 12%, respectively. The present method was used for pharmacokinetic studies for BAMs in plasma samples. Copyright © 2012 John Wiley & Sons, Ltd.     

Development and validation of a liquid chromatography–tandem mass spectrometry method for topotecan determination in beagle dog plasma and its application in a bioequivalence study

Topotecan (TPT) is an important anti‐cancer drug that inhibits topoisomerase I. A sensitive and robust liquid chromatography–tandem mass spectrometry (LC‐MS/MS) method that potentially determines TPT in beagle dog plasma is needed for a bioequivalence study of TPT formulations. We developed and validated LC‐MS/MS to evaluate TPT in beagle dog plasma in terms of specificity, linearity, precision, accuracy, stability, extraction recovery and matrix effect. Plasma samples were treated with an Ostro^TM sorbent plate (a robust and effective tool) to eliminate phospholipids and proteins before analysis. TPT and camptothecin (internal standard) were separated on an Acquity UPLC BEH C₁₈ column (1.7 µm, 2.1 × 50 mm) with 0.1% formic acid and methanol as the mobile phase at a flow rate of 0.25 mL/min. TPT was analyzed using positive ion electrospray ionization in multiple‐reaction monitoring mode. The obtained lower limit of quantitation was 1 ng/mL (signal‐to‐noise ratio > 10). The standard calibration curve for TPT was linear (correlation coefficient > 0.99) at the concentration range of 1–400 ng/mL. The intra‐day and inter‐day precision, accuracy, stability, extraction recovery and matrix effect of TPT were within the acceptable limits. The validated method was successfully applied in a bioequivalence study of TPT in healthy beagle dogs. Copyright © 2013 John Wiley & Sons, Ltd.